IGS-NT Communication Guide
61
Controller setup
(Setpoints/Comms settings group)
Act. calls/SMS: AcallCH1(-3)-Type = IB-E-MAIL
Act. calls/SMS: AcallCH1(-3)-Addr = email address (maximum length of email address is 31 characters)
Act. calls/Acall+SMS lang: AcallCH1(-3)-Addr = 1, 2, 3, ...
Note: Number of language corresponds with number of language in GenConfig (card āLanguagesā).
4.7 Access Lock
This functionality limits access to the controller, from fully control to monitoring only (it means that commands
are blocked, no setpoint changes).
The reading all values is still available, change the screens on displays is available. Access Lock is located at
LBI card in GenConfig and can be attached to binary input.
6 back to Remote monitoring
To Next Page
Loading...
