COMBAT
®
CTU UNIT HEATERS INSTALLATION OPERATION AND SER VICE MANUAL
2 of 46
SECTION 1: HEATER SAFETY
Yo ur Safety is Important to Us!
Th
is symbol is used throughout the
manual to notify you of possible fire,
electrical or burn hazards. Please pay
special attention when reading and
following the warnings in these sections.
Installation, service and annual inspection of heater
must be done by a registered installer/contractor
qualified in the installation and service of gas-fired
heating equipment.
Read this manual carefully before installation,
operation, or service of this equipment.
This heater is designed for heating non-domestic
indoor spaces. Do not install in domestic spaces.
These instructions, the layout drawing, local codes
and applicable standards that apply to gas piping,
electrical wiring, venting, etc. must be thoroughly
understood before proceeding with the installation.
Protective gear is to be worn during installation,
operation and service. Thin sheet metal parts of the
heater and the various venting components have
sharp edges. To prevent injury, the use of work
gloves is recommended.
Before ins
tallation, check that the local distribution
conditions, nature of gas and pressure, and
adjustment of the appliance are compatible.
The heater must be applied and operated under the
general concepts of reasonable use.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do no play with the appliance.
For additional copies of the Installation, Operation
and Service Manual, please contact Combat HVAC
Limited.
1.1 Manpower Requirements
To prevent personal injury and damage to the
heater, two persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer legible.
Contact Combat for obtaining replacement signs or
labels. See Page 2, Figure 1 through Page 3,
Figure 2.
Figure 1: Side and Back Panel Label Placement
Description Part Number
Logo Label 91040030
Lockout Reset Label 91038303
Address Label 91040006
Rating Plate Label 91040001
Ema
il: uksales@combat.co.uk
Ema
il: ukservice@combat.co.uk
Combat HVAC Limited
Uni
t 20 Red Mill Trading Estate
Rigby Street, Wednesbury
West, Midlands, WS10 0NP
www.combat.co.uk
C
ombat HVAC Limited
Email: uksales@combat.co.uk
Email: ukservice@combat.co.uk
Combat HVAC Limited
Unit 20 Red Mill Trading Estate
Rigby Street, Wednesbury
West, Midlands, WS10 0NP
www.combat.co.uk
Combat HVAC Limited
To Next Page
Loading...
