CommScope Era
™
Fiber Low Power Carrier Access Point Installation Guide M0201ANC_uc
Page 24 © June 2019 CommScope, Inc.
Mount the Fiber CAP L
MOUNT THE FIBER CAP L
A Fiber CAP L is suitable for indoor and outdoor installations as follows:
• Indoors—All vers
ions of the Fiber CAP L can be installed indoors.
• Outdoors—Only Fiber CAP Ls with the optional Fan Kit can be
installed outdoors.
Mounting instructions are divided into the sections listed below. Follo
w the mounting instructions that are
applicable to this installation:
• "Flat-Surface Mount a CAP L” on page 27
• "Wall Mount a CAP L” on page 29
– "Mounting Orientation for Wall Mounts” on page 29
– "Wall Mount a CAP L Using a Flat Mounting Br
ack
et Kit” on page 30
– "Mounting Two CAP Ls with a Dual Mounting Kit” on page 31
– "Mounting a CAP L with an AC/DC Power Supply Kit” on page 38
– "Mounting a CAP L with a Hybrid Fiber Splice Box Kit
” on page 43
• "Ceiling Mount a CAP L” on page 54
– "Ceiling Mount a CAP L without a Fan Kit” on page 54
– "Ceiling Mount a CAP L with a Fan Kit” on page 54.
General Mounting Cautions
The following cautions apply to all Fiber CAP L installations; there may be other mounting cautions applicable
to a specific mounting option, which will be defined in the applicable mounting procedure.
Attach all CAP Ls securely to a stationary object as described in this installation guide.
To maintain proper ventilation, keep at least 76 mm (3-inch) clearance around the CAP L.
The installation site must be able to bear the weight of the CAP L; see Table 8 on page 21.
To Next Page
Loading...
Need help?
General
