CommScope ERA CAP M2

To Next Page

To Previous Page

CommScope ERA

CAP M2 with Fiber Interface M0203AHA_uc

Mount the Fiber CAP M2

5 Secure the wall mount bracket to the wall, using four anchor screws.

Main Page

Table of Contents3
Document Overview5
Document Revision History5
Document Cautions and Notes5
Abbreviations Used in this Guide6
Safely Working with ERA Hardware6
Health and Safety Precautions6
Property Damage Warnings7
General Installation Safety Requirements7
Guard against Damage from Electro-Static Discharge7
Compliance8
Equipment Symbols Used / Compliance10
Maximum Output Power Levels11
Required Antenna Distances11
Fiber CAP M2 Overview12
Connectors and LED for the Fiber CAP M212
CAP M2 Accessories and Options13
Mounting Kits13
SFP+ Module Kits14
OCTIS™ Universal Lever Assembly Kits15
OCTIS Universal Lever Assembly Instructions15
Plan and Prepare for a Fiber CAP M2 Installation17
Maximum Number of Fiber CAP M2S Supported in an ERA System17
Determine the Power Consumption of the CAP M218
Determine the CAP M2 Installation Site18
CAP M2 Dimensions19
CAP CAP M2 Weights19
Recommended Tools and Material20
Unpack and Inspect the CAP M2 and Optional Accessories20
Obtain the Required Materials20
Mount the Fiber CAP M221
General Mounting Cautions21
Wall Mount a CAP M222
Mounting Orientation for Wall Mounts22
Mounting CAP M2 with a Wall Mounting Kit23
Mounting a CAP M2 with a Hybrid Fiber Splice Box Kit (Optional)26
Prepare for CAP M2 Hybrid Fiber Splice Box Kit Installation27
Assembling and Wiring the Hybrid Fiber Splice Box27
Wire the Hybrid Fiber Splice Box27
Wall Mount a CAP M2 Using a CAP M2 Hybrid Fiber Splice Box Kit (Optional)31
Connect the Cables to the Fiber CAP M232
Ground the Fiber CAP M2 (Optional)32
Connect the Fiber CAP M2 to a Passive RF Antenna33
Clean the RF Cable Connectors34
Connect the Passive RF Antenna36
Connect the Optical Fiber37
Installing SFP+ Modules in the CAP M238
Connect the Fiber CAP M2 to a Classic CAN or TEN40
Powering on a Fiber CAP M 241
CAP M2 AC Power Cable41
CAP M2 DC Power Cable42
Connect the CAP M2 Power43
Connect the Mains Power to the CAP M243
Connect a Hybrid Fiber Splice Box44
Power the CAP M245
Contacting Commscope46
CMS Global Technical Support46
Telephone Helplines46
Online Support46
Waste Electrical and Electronic Equipment Recycling46
Hardware to Software Mapping Information47

CommScope ERA CAP M2 - Page 24

Table of Contents

Related product manuals