Compact Electric CDMRE 100 - General 3

compact electric CDMRE 100 Manual Page 13
1230 Vienna, Großmarktstraße 22
PHONE: + 43 / 1 / 815-12-71-0 or + 43 / 1 / 815-51-74-0
FAX: + 43 / 1 / 813-64-21-21
Homepage: http://www.compactelectric.at
CDMRE100e_man_A5.docx
3.6. General 3
The 6th menu item shows the parameterization of general settings 3.
Code: You can set the activation code here. When you set the code
“0000”, the code lock is deactivated.
The code lock can be configured and reset only on CDMRE-100
(by entering “0 0 0 0”). When a code is set, it is always requested
before changing a parameter. You can view the measured val-
ues, parameters and the event log even without entering a code.
The "Current code" input field is implemented in the communi-
cation program so that parameters can still be transferred to the
CDMRE via the communication program when the code lock is
switched on. The entry of the current code via this field is valid
until the "Receive parameters" menu is called up or the commu-
nication program is restarted.
Date/time: You can view and manually set the date and time here.
When “sending parameters" using the PC software via the serial
interface, the time and date are automatically transferred from
the PC or laptop.
Block: The blockade input has the functions "Switch-on blockade NO
(Normally Open)", "Switch-on blockade NC (Normally Closed)",
"Trigger blockade" and "Off".
If the "Switch-on blockade NO" is active, the relay is prevented
from being switched on as long as a connection is established
between inputs "B" and "". After the connection between "B"
and "" has been opened (if all connection conditions are ful-
filled), the relay is switched on after the set blocking time has
elapsed.
If the "Switch-on blockade NC" is active, the relay is prevented
from being switched on as long as a connection between inputs
"B" and "” is open. After the connection between "B" and ""
has been closed (if all connection conditions are fulfilled), the
relay is switched on after the set blocking time has elapsed.
If the “trigger blockade" is active, the relay always remains en-
ergized as long as a connection is established between inputs
"B" and "".
EvtLog Cl: The event log can be deleted by entering the number "14” in the
"EvtLog Cl" line. By entering the number "69" in this line,
CDMRE-100 is restarted (reset).