40
and depends on whether a 20 MHz channel or 40 MHz channel
is being used.
Sets this field to limit the number of clients which allow
connecting to this SSID and this is a number between 0 and 16.
Set to 0 indicates no limitation.
Enable or disable this wireless interface.
Select the channel width (20 MHz or 20/40 MHz) to be used by
CH6643E. When 20/40MHz is selected 802.11n clients
experience improved throughput using 40 MHz, while legacy
clients(either 802.11a or 802.11b/g) can still be serviced without
interruption using 20MHz.
Specify if the extension channel should be in the Upper or Lower
sideband. This field is only shown when “Channel Width” is set to
20/40 MHz.
Select primary (control) channel is in the lower or upper 20 MHz
band of the bonded 40 MHz channel.
Select the current channel number or control channel, you can
select “Select Best Quality Channel Automatically” check box to
auto select one, this value depend on Transmission Mode.
Select the physical layer transmission rate used for Multicast
traffic on the wireless interface, this value depend on
Transmission Mode.
Wireless Security Page
This page allows you to protect your Wi-Fi wireless network by specifying WEP, 802.1x,
WPA, or WPA2 wireless security. Before setting up security, ensure that your wireless
adaptors support the same type of security.
The default type of security is Mixed WPA-PSK/WPA2-PSK. Field of Mixed WPA-
PSK/WPA2-PSK, WPA2-PSK and WPA-PSK are the same.
To Next Page
Loading...