Compaq Deskpro 4000N - Switch Mounting Bracket Assembly

Compaq Deskpro 4000S and 4000N Personal Computers 5-27
5.15.2 Switch Mounting Bracket Assembly
The switch mounting bracket assembly is comprised of the power switch and the power switch
mounting bracket. The two parts are spared as unassembled components and must be assembled prior
to installation.
CAUTION:
Compaq does not recommend removing the switch from the mounting bracket.
To assemble the components, complete the following steps:
1. Align the switch with the opening in the back of the mounting bracket and push the two pieces
together. The design of the parts prohibits the pieces from being installed improperly.
2. Insert the black wired LED into the upper socket and the white one into the lower socket. The
wire colors are clearly marked on the rear of the mounting bracket.
Figure 5-18.
Assembling the Switch Mounting Bracket Components