Compaq Deskpro 4000S and 4000N Personal Computers 5-9
5.6 Cable Lock
To install the cable lock provision, complete the following steps:
1. Separate the pieces of the security bracket by bending the metal where the three pieces join (see
inset).
2. Insert the tang of the narrow bracket into the slot and slide the U-shaped bracket between it and
the system unit cover (see inset); then, install the self-tapping screw included in the cable lock
kit.
3. Cover the screw with the flat portion of the bracket.
4. Install a lock (not provided) to secure the top part of the security bracket to control access to the
inside of the computer. Install a cable lock (not provided) to secure the computer to a secure
place.
Figure 5-5.
Installing the Cable Lock
To remove the cable lock provision, reverse the above procedure.
To Next Page
Loading...
