Compaq Deskpro 4000N - Inch Hard Drive

5-38 Removal and Replacement Procedures
5.17.3 3.5-Inch Hard Drive
This section applies only to the Deskpro 4000S.
The 3.5-inch hard drive is located on the right side of the computer, in the lower position.
To remove the drive, complete the following steps:
1. Prepare the computer for disassembly (Section 5.4).
2. Remove the system unit cover (Section 5.7).
3. Remove the Slimline CD-ROM drive, if present (Section 5.17.2).
4. Rotate the drive bay to the upright position.
5. Disconnect the cables from the back of the drive.
Figure 5-28.
Disconnecting the Cables From the Back of the Hard Drive