Compaq Deskpro 4000N - Power Switch Cable Components; Switch Cable Assembly

Compaq Deskpro 4000S and 4000N Personal Computers 5-25
5.15 Power Switch Cable Components
This section is subdivided into two parts: the switch cable assembly and the switch mounting bracket
assembly.
5.15.1 Switch Cable Assembly
The switch cable assembly consist of two parts: the switch mounting bracket assembly and the
switch cable.
To remove the switch cable assembly from the chassis, complete the following steps:
1. Prepare the computer for disassembly (Section 5.4).
2. Remove the system unit cover (Section 5.7).
3. Rotate the drive cage to an upright position.
4. Disconnect the switch cable assembly from the system board.
5. Remove the switch mounting bracket assembly from the chassis by squeezing the tab on top of
the bracket and then lifting the bracket up and out of the chassis.
Figure 5-17.
Disconnecting the Switch Cable