5-30 Removal and Replacement Procedures
5.16.3 Bezel Blank
This operation applies to the Deskpro 4000S only.
To remove the bezel blank, complete the following steps:
1. Prepare the computer for disassembly (Section 5.4).
2. Remove the system unit cover (Section 5.7).
3. Set the system unit cover with the top down on a protected work surface. Squeeze together the
sides of the right end of the bezel blank to release the catches.
4. Remove the bezel blank from the front bezel.
Figure 5-21.
Removing the Bezel Blank (Deskpro 4000S Shown)
To reinstall the bezel blank, reverse the above procedure.
To Next Page
Loading...
