Compaq Deskpro 4000S and 4000N Personal Computers 5-13
5.9 Expansion Board Cage
The removable expansion board cage is spared from the factory with the backplane installed. To
remove the expansion board cage, complete the following steps:
1. Prepare the computer for disassembly (Section 5.4).
2. Remove the system unit cover (Section 5.7).
3. Pull the expansion board cage straight up to remove it from the chassis.
Figure 5-9.
Removing the Expansion Board Cage on a Deskpro 4000S
To replace the expansion board cage, reverse the above procedure.
✎
When installing the expansion board cage, ensure that the tab on the cage latches into the slot
on the side of the power supply.
To Next Page
Loading...
