5-4 Removal and Replacement Procedures
5.2.2 Mounting Bracket Method
CAUTION:
Do not mount the computer upside down when using this method.
To install the optional mounting bracket, complete the following steps:
1. Position the mounting bracket in the desired area and mark through the mounting holes to
accurately locate where the fasteners will be installed.
2. Drill pilot holes in the mounting surface if required to accept the fasteners.
3. Install the fasteners through the mounting bracket.
CAUTION:
Make sure you use the proper fasteners to suit the material to which the mounting bracket will
be installed. Failure to select the proper fasteners may result in damage to the computer.
Figure 5-3.
Installing the Computer Mounting Bracket
The computer may now be inserted into the mounting bracket.
✎
The cable lock provision may be used with this option. Refer to Section 5.6 for more
information.
For more information, refer to the document supplied with the option kit.
To Next Page
Loading...
