5-36 Removal and Replacement Procedures
CAUTION: Check the position of all cables and wires before raising or lowering the drive cage to prevent
cable damage.
9. Return the drive cage to the normal position.
10. If you have installed an audio board to the computer, attach the audio cable from the system
board at J11 to the audio board at this time.
11. If it is necessary to remove the expansion board cage to attach the audio cable, refer to
Section 5.9.
Figure 5-27.
Attaching the Audio Cable to the System and Audio Boards
12. Remove the bezel blank from the front bezel (Section 5.17.3).
13. Install the system unit cover (Section 5.7).
To Next Page
Loading...
