Comtec ZDR-024CE - Page 53

53
Setting
LCD brightness settings
• The brightness of video images can be selected from [Bright/Stan-
dard/Dark].
• By default, it is set to [Standard].
Screen display settings
• Display settings for the LCD can be selected from [OFF/Speed-
linked/ON (continuous)/Clock (small)/Clock (large)].
• By default, it is set to [Speed-linked].
Ŷ6HWWLQJVFRQWHQW
[OFF] ................... Does not show the LCD. Each time the [Menu/Return] switch is pressed,
WKHGLVSOD\LVVZLWFKHGRQRURႇ7KHGLVSOD\ZLOOWXUQRႇDIWHUVHFRQGV
[Speed-linked] ....... When travelling at 10km/h or faster after receiving a GPS signal, the LCD
will be switched to non-display mode.
The LCD will still be in non-display mode after stopping your car. However,
by pressing the [Menu/Return] switch, the LCD will show video footage
until your car once again reaches a speed of over 10 km/h.
[ON (continuous)] ....... The LCD is displayed continuously.
[Clock (small)]
....... At start up and after operating the main unit, it will show the recording
screen for 30 seconds before switching to a display of a clock.
[Clock (large)] ....... At start up and after operating the main unit, it will show the recording
screen for 30 seconds before switching to a display of a clock/calendar.
5HFRUGLQJQRWL¿FDWLRQVHWWLQJV
• You can select the sound at startup from [OFF/Alarm/Voice].
• By default, it is set to [Alarm].
You cannot select [Voice] when [Language] has been set to a language other than
[Japanese]. (=> P 57)
/HDGLQJYHKLFOHVWDUWXSQRWL¿FDWLRQVHWWLQJV
• As for detection and notifications for cars ahead of you that start
moving when your car is stopped, you can select from [OFF/Alarm/Voice].
• By default, it is set to [OFF].
You cannot select [Voice] when [Language] has been set to a language other than
[Japanese]. (=> P 57)
Setting