Comtec ZDR-024CE - Page 54

54
)URQWVLJQDOQRWL¿FDWLRQVHWWLQJV
• As for detection and notifications of green traffic signals ahead of
your car while stopped, you can select from [OFF/Alarm/Voice].
• By default, it is set to [OFF].
You cannot select [Voice] when [Language] has been set to a language other than
[Japanese]. (=> P 57)
Drive support settings
• $VIRUGHWHFWLRQDQGQRWL¿FDWLRQVRI*DFFHOHUDWLRQGHFHOHUDWLRQZKHQDFFHOHUDWLQJ
and decelerating too abruptly, etc., you can select from [OFF/Alarm/Voice]. You can
use this function as a guide for eco-driving. The long-drive announcement function
will be turned ON/OFF by linking it to this function.
• By default, it is set to [OFF].
* It does not notify you when the G sensor has been set at 0.3G or less.
You cannot select [Voice] when [Language] has been set to a language other than
[Japanese]. (=> P 57)
Advice
• Levels of detection will change in accordance with the settings of the G sensor.
• By driving without activating the alarm, you can avoid accelerating/decelerating too abruptly.
• Drive support may not work when you are recording video footage owing to switch operation
or an impact.
• You cannot turn on only the long-drive announcement function.
◇
Long-drive announcement function
When you have been driving for two hours without a rest, the following announcement
will be made.
* The message will be announced even when the main unit has been set to [Alarm].
“It has been two hours since you started driving. It is about time for a break.”
Vehicle speed alarm settings
• It makes an announcement when you exceed a preset speed. It
does not repeat the alarm for one minute after the alert.
• You can select from [OFF/30 to 140 km/h]
• By default, it is set to [OFF].
Setting