NetPerformer SDM-8400 Hardware Installation Guide
3-10 Memotec
1. Ensure that the SDM-8400 unit has successfully powered up with no system status
errors (see “System Status on Power-up” on page 3-8).
2. Power the console terminal on or start your console terminal emulation program.
Take note of:
• “Important Console and Modem Settings for Startup” on page 3-9
• “Concerning HyperTerminal Connections” on page 8-1.
3. When you see the prompt
Type <ENTER> to connect, press the <Enter> key on the
console terminal keyboard several times, until the SDM-8400 responds with a prompt
for the user login.
4. Enter the administrator login:
ADMIN.
NOTE: This is the default login. Additional user logins can be defined. For details,
refer to the chapter Controlling Access to the NetPerformer in the Quick Con-
figuration section of the NetPerformer Reference Guides.
5. Enter the password for this login. The default password for the administrator login is
SETUP.
When the password is entered correctly, the SDM-8400 sends the product banner to
the console screen, as in this example:
LOGIN:ADMIN
PASSWORD:*****
ACCEPTED
SDM-8400 vx.x.x Memotec Inc. (c) 2007
Signaling Engine x.x.x
Console connected on port CSL
B302417>
6. Enter the Display Alarms (DA) command at the NetPerformer console command line
to verify that your unit is problem free. In particular, look for any alarm messages that
indicate
Call Technical Support.
To Next Page
Loading...