NetPerformer SDM-8400 Hardware Installation Guide
4-4 Memotec
State Interpretation
Blinking Red/Amber/
Green
Early stage of system startup, when the bootstrap
program is executing a hardware self-test.
Red
A software reset has occurred.
a
a. To turn the
AL LED off, enter the CE (Clear ERR/DIAG LED) command
at the console command line. Refer to the NetPerformer User Guide.
Amber A Write operation to Flash memory is in progress, e.g.
while saving the application after a download.
Green Hardware initialization is in progress.
Off No alarm has occurred on the unit since the alarms
were last cleared.
Table 4-3: AL LED states
To Next Page
Loading...