4
O p e r a t i o n
S t a r t i ng th e D r yer
To start the dryer:
1 Turn on the main power to the dryer and system components. Check to make sure
that all disconnect dials are in the “ON” position.
2 Fill the drying hopper with material.
3 Navigate to the Dryer
Detail screen.
4 Enter setpoints as
necessary on this
page. (Depending on
your dryer configura-
tion, you may need to
make settings to the hopper heater by pressing the zoom button beside the hopper
heater.)
5 Press the green start button beside the dryer graphic to start the dryer system.
ResinWorks configuration Stand alone configuration
125
-40
NOTE: The Start and Stop buttons will appear as grey when that function is not available, and bright when
it is available. The greyed buttons mean that the dryer can not be stopped or started at this time. For
example, when the dryer is running, the green button is greyed. The dryer can not be started because it is
already running. Similar conditions may occur during cool down or start up.
✐
O p e r a ti o n l 4 - 8 3
To Next Page
Loading...
Need help?
General
