I n s t a l l a t i o n l 3 -3
3
I n s t a l l a t i o n
P r e p a r in g f or Ins t al l at i on
The Carousel Plus W Series Dryer is easy to install if you plan the location and prepare the
mounting area properly.
1 Make sure the mounting area provides:
❒
A grounded power source supplying the voltage and correct current for your
dryer model. Check the dryer’s serial tag for the correct amps, voltage, phase, and
cycles. Field wiring should be completed by qualified personnel to the planned loca-
tion for the dryer. All electrical wiring should comply with your region’s electrical
codes.
❒
A source of water, if you have an aftercooler and/or optional precooler.
The W dryer’s aftercooler and optional precooler require 3 gals./min. {11.4 liters/min.}
tower, city, or chiller water at temperatures of 45° to 85°F {7° to 29°C}. Pipe should
be run to the planned dryer location. Use flexible hose to connect the water pipes to
the aftercooler and/or optional precooler.
❒
Minimum clearance for safe operation and maintenance.
You should maintain 24 in. {61 cm} clearance on all sides of the dryer.
Po si t i o n i n g th e D r yer on th e Fl o or
1 Lift the dryer from the shipping container using a fork truck.
2 Position the dryer on the floor near the processing machine. Make sure the
location allows for the connection of all hoses.
R e m o vi n g t he Ca b le Ti e f ro m t h e
D e s i c c an t W he e l
1 Open the dryer side panels and remove the cable tie securing the desiccant wheel, if
it was not done while unpacking the dryer.
Material and conveying
lines installed. If you
plan to use vacuum or
compressed air loaders
to fill the hopper, install
conveying lines to the
drying hopper location.
✒
Desiccant cable tie
To Next Page
Loading...
Need help?
General
