6
Tr o u b l e s h o o t i n g
Tr o u b l es h oo t in g l 6- 3 7
R e p l a c i n g t he De s i cc a nt Wh e el Mo t o r
1 Stop the dryer, disconnect and lockout the main power.
2 Open both side panels.
3 Disconnect wiring to the motor.
4 Loosen the belt tensioner and remove the pivot bolt securing the belt tensioner to
the motor bracket. Be sure to retain the flat washers located under the tensioner.
Disconnect the spring and remove the tensioner.
5 Remove the belt from the motor pulley, then remove the pulley from the motor.
6 Remove the screws securing the motor to the upper and lower bracket, and remove
the motor.
7 Secure the new motor to the bracket.
8 Install the pulley on the new motor, and position the belt on the pulley.
9 Connect the spring to the tensioner, then secure the tensioner to the motor brack-
et. Be sure to install flat washers between the motor bracket and the tensioner.
10 Connect the wires to the motor.
11 Connect the power to the dryer. Turn the dryer on and ensure that the desiccant wheel
is rotating in the correct direction.
12 Replace the side panels.