5 - 6 l M ai n te n an c e
C l e a n i n g th e P r o c e ss Fi l te r ( co n t i n u ed )
4 Remove outer filter and clean it with soapy water.
Let air dry.
5 Clean the filter by laying it on its side and
gently tapping it on the floor. Replace
damaged, worn, or clogged filters.
6 Reverse the procedure to reinstall the process
filter. Ensure that the gasket on filter cap is in
place and in good condition.
CAUTION: Wear eye protection. If you use
compressed air to clean the equipment, you
must wear eye protection and observe all
OSHA and other safety regulations pertaining to
the use of compressed air.
TIP: If gasket on the process filter cap becomes loose or detached from the filter cap, resecure with
high temperature silicone adhesive.
✒
To Next Page
Loading...
