4
O p e r a t i o n
C o n t r o l Fun c ti o n D es c ri p ti o ns - R W
C o n f i g u r a ti o n
( c o n ti n ue d )
DM3-e Hopper Settings Screen (if equipped)
To access the DM3-e Hopper Settings screen:
1 Press the Magnifying Glass (zoom) button associated with the Drying Monitor (beside
the temperature zones).
The DM3-e Hopper Settings Screen provides the user with the current alarm location zone,
and the Alarm Setpoint, as well as a button to enable or disable DM3-e for this hopper.
These settings can be adjusted for each hopper in your DM3-e system.
NOTE: See the Appendix of this
User Guide for more information
about using the DM3-e Drying
Monitor.
✐
(continued)
Ready to Run
NOTE: The Drying Monitor
board version number is listed
on the bottom of this p op up
window. This information is
helpful for service and trou-
bleshooting.
✐
O p e r a ti o n l 4 - 2 1
To Next Page
Loading...
