Electronic components and circuits are sensitive to
Electrostatic Discharge (ESD). When handling any circuit
board assemblies including Connect Tech COM Express
carrier assemblies, it is recommended that ESD safety
precautions be observed. ESD safe best practices include,
but are not limited to:
• Leaving circuit boards in their antistatic
packaging until they are ready to be installed.
• Using a grounded wrist strap when handling
circuit boards, at a minimum you should touch a
grounded metal object to dissipate any static
charge that may be present on you.
• Only handling circuit boards in ESD safe areas,
which may include ESD floor and table mats,
wrist strap stations and ESD safe lab coats.
• Avoiding handling circuit boards in carpeted
areas.
• Try to handle the board by the edges, avoiding
contact with components.
ES France - Mobilité & Systèmes Embarqués
127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 80
Fax. 01 47 01 16 22
e-mail : mse@es-france.com
Site Web : www.es-france.com
To Next Page
Loading...