Contec ADI16-4(USB) - 7. Product Specification; Hardware and Environmental Specifications

7. Product Specification
ADI16-4(USB)
53
7. Product Specification
Hardware Specification
Table 7.1 lists the hardware specification of ADI16-4(USB).
Table 7.1. Hardware Specification < 1 / 2 >
Item
Specification
Analog input
Input format Bus-isolated voltage / current input
Input range
Voltage: Bipolar ±10V
Current: 0 - 20mA
Maximum input rating
Voltage: ±20V
Current: 30mA
Input impedance
Voltage: 1M
Ω
(Min.)
Current: 250
Ω
(Typ.)
Input channel Different input 4 channels
Resolution 16 bits
Non-linear error
Voltage: ±8LSB(±0.012% of FSR) *1
Current: ±20LSB (±0.030% of FSR) *1
Conversion rate
Voltage: 10
µ
sec
/ch
+20
µ
sec *2
Current: 40
µ
sec
/ch
+20
µ
sec *2
Data buffer 256K data (262,144 data)
Internal sampling timer 10
µ
sec - 1,073,741,824
µ
sec *3
Communication
USB transmission speed 12Mbps(full speed), 480Mbps(high speed) *4
Current consumption +5VDC 600mA(Max.) *5
Others
Number of modules used
at the same time
127 modules (Max.) *6
Use condition*7 0 - 50
°
C, 10 - 90%RH(No condensation)
Physical dimensions (mm) 50.4(W) x 64.7(D) x 94.0(H) (exclusive of protrusions)
Weight of the module itself 100g
Module installation
method
One-touch connection to 35mm DIN rails (standard connection mechanism
provided
in the system)
Expansion module
ADI16-4(FIT)GY : 3 modules (Max.),
Current consumption per one module : +5VDC 300mA(Max.)
Connectors
FRONT-MC 1,5/12-STF-3,81 (made by PHOENIX CONTACT)
3.81mm-pitch nominal current: 4A(Max.)
Applicable wire AWG28 - 16
Bundled AC adapter
(POA200-20-2)
90 - 264VAC 5.0VDC±5% 2.0A(Max.)
Length of cable is about 1.5m. Length of AC cable is about 1.5m.
*1 For this product, as the analog signal is input to A/D converter without being processed in order not make the
frequency characteristics to deteriorate, if the connection cable is affected by noise, correct analog input may not be
achieved.