Commander SE User Guide
56 Issue Number 5
•Pressthe STOP key to STOP the Drive. The display should show:
3. If the Drive trips during these tests the display will show, for example
The right hand display will flash with the trip code
4. Press the RESET button to reset the trip. Press the RUN button to
run the Drive.
5. The FORWARD/REVERSE button can be enabled by setting parameter 26
=On.
If this test has been carried out as a bench test and the Drive is to be
connected to a different motor with different characteristics etc. in the
application, then the motor map parameters should be set to the correct
values for the new motor and another autotune carried out (see parameter 38
for details).
rd
0.0
tr
OU
NOTE
To Next Page
Loading...
Need help?
General
