Control Techniques M'Ax 406 User Manual

*
M’Ax User Guide 51
Issue Number: 4
9 Advanced Parameters
These parameters are listed for reference purposes
only; the lists do not include sufficient information for
adjusting the parameters.
In some cases, the function or range of a parameter are affected by
the setting of another parameter; the information in these lists
relate to the default condition of such parameters.
Key
RW
Read-write parameter
Read-write (RW) parameter whose default
value is defined by the motor via the
SLM
RO
Read-only parameter
Read-only parameter whose value is definedby
the motor via the
SLM
{...} Related Menu 0 parameter
[...] Value of a parameter
Uni
Unipolar variable parameter
Positive values only
Bi
Bipolar variable parameter
Positive and negative values
Txt
Text variable parameter
Alphanumeric code is displayed
Bit
Bit parameter
Two digital states only
R
Parameters must be copied to the EEPROM (saved) or
copied to the flash memory (stored) for a new value to take
effect
S
A new value is normally copied to the EEPROM (saved) or
copied to the flash memory (stored) at power-down (see
parameter
0.50 Parameter transfer function selector in
Chapter 8 Menu 0 Parameters)
P
Protected
The parameter cannot be controlled by an external signal
(cannot be a destination parameter)
n
MAX
Maximum speed of the motor
(defined by the motor via the
SLM)
[SLM] Value defined by the motor via the
SLM
WARNING
NOTE

Control Techniques M'Ax 406 Specifications

General

Brand	Control Techniques
Model	M'Ax 406
Category	Servo Drives
Language	English