Grab Bar
For models that accept grab bars, attach
one end of grab bar to the armrest tube.
Pull other end of telescoping grab bar in
direction shown in
Fig. 70 and attach.
Not available on Transit Models.
18
Headrest Cover (Canopy)
Fig.69
ACCESSORIES
1. Move rubber spacers to
adjust height of the canopy.
2. Insert canopy rod into
tube located on seat back
(or headrest extension if
being used).
Fig. 69
3. Continue to push until
the extended end locks
into place.
Note:
Partially
fold chair
before
installing
canopy.
Fig.70
1. To open, loosen knobs
and unfold metal rods.
4. To fold, perform above steps in reverse.
2. Pull open than place hand
near pivot and push down
on the extended end.
Unfolding/Folding Canopy:
To Next Page
Loading...
