Copley Controls Xenus XSL - G.2: Servotube Auto Phase and Manual Phase; G.2.1: Servotube Auto Phase

Xenus XSL User Guide ServoTube Motor Setup
Copley Controls Corp. 189
G.2: ServoTube Auto Phase and Manual Phase
G.2.1: ServoTube Auto Phase
NOTE: The following steps use a ServoTube motor. For short stoke ServoTube motors with less
than 2 electrical cycles, proceed to G.2.2: ServoTube Manual Phase (p. 192).
G.2.1.1 Verify that the Enable Input is not activated.
G.2.1.2 Apply power.
G.2.1.3 Click Auto Phase ( ) to open the Auto Phase Motor Direction Setup screen.
G.2.1.4 Move the motor in the direction you wish to be considered positive.
The Actual Position value on the screen should change. If it does not change, see
Trouble Shoot Motor Direction Setup (p. 109).
G.2.1.5 Activate the Enable Input.
G.2.1.6 Click Next to display the Auto Phase Motor Wiring Setup screen.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com