ProLine 124-221-321-324 Operator manual 101
UK
1. Never exceed these pressure limitations:
220 psi (16 bar).
150 psi (10 bar).
pressure indicated by the manufacturer on the sidewall of the tyre itself.
2. Activate the air inflation jets only when inserting the bead.
3. Fully bleed air pressure system before disconnecting power supply line or other
pneumatic components. Air is stored in a reservoir to operate the inflation jets.
4. Activate the air inflation jets only if the rim is correctly clamped on the tyre changer (if
required) and the tyre is completely mounted.
1.3. ADDITIONAL RIM/TYRE INFORMATION
Wheels equipped with pressure sensors and special rims or tyres could require
particular work procedures. Consult wheels and tyre manufacturer’s service
manuals.
WARNING
1.4. INTENDED MACHINE USE
This machine must only be used to demount and mount vehicle tyres from/on the rims,
using the provided tools. Any other use is improper and may result in injury.
1.5. PERSONNEL TRAINING
1. Employers are responsible for providing a training program for all employees who
work on the wheels concerning the hazards deriving from maintenance and the safety
procedures to be observed. Service or maintenance refer to mounting and demounting
wheels and all the correlated activities, such as inflation, deflation, installation, removal
and handling.
they have received suitable training regarding the correct maintenance procedures for
the type of wheel being serviced and the operative safety procedures.
contained in this manual.
2. Employers are required to make sure that every employee demonstrates and maintains
the ability to work on the wheels safely, including the performance of the following
activities:
To Next Page
Loading...
