102 ProLine 124-221-321-324 Operator manual
the wheel during inflation.
3. Employers must evaluate the ability of their employees to carry out these tasks and
work on the wheels in absolute safety and must provide additional training as required
to make sure that all employees maintain their skills.
1.6. PRELIMINARY CHECKS
Before starting to work, carefully check that all machine components, particularly rubber
or plastic parts, are in place, in good condition and operate correctly. If the inspection
reveals any damage or excessive wear, no matter how slight, immediately replace or repair
the component.
Walk around the machine to ensure that all components are in good condition and
operational, and that there are no foreign objects or debris (rags, tools, etc.…) in or near
the machine which could affect its operation.
These checks must be carried out:
The machine may only be started after this pre-use check is successfully completed. Do
not use the machine if it is placed out of service for tune up, maintenance, lubrication, etc.
1.7. DURING USE
If strange or unusual noises are heard or any unusual vibration is detected, if a component
or system is not operating correctly or if you observe anything unusual, immediately stop
using the machine.
Make sure that all other people are standing at least 6 metres (20 feet) from the machine.
To switch off the machine in case of emergency:
WARNING
The interruption of the pneumatic supply can leave some actuators
under pressure as indicated by the pictogram affixed on the machine.
Use the controls to bleed the air they contain.
1.8. OPTIONAL ACCESSORIES
Contact the sales network to find all the optional accessories suitable for this machine.
To Next Page
Loading...
