Corghi ProLine 124 - Approved Uhp and Run Flat Tyre Demounting and Mounting Procedure; Tyre Inflation; Safety Indications

ProLine 124-221-321-324 Operator manual 127
UK
- Once you have mounted the first bead,
repeat the same steps for the second bead
(fig.29).
- Move the operating arms to the “non-
working” position.
- release the wheel and remove it from the
tyre changer.
Special tools
To make it easier to mount/demount low
profile tyres, it is advised to use the bead
presser gripper (optional accessory supplied
on request).
9.7 APPROVED UHP AND RUN FLAT TYRE DEMOUNTING AND
MOUNTING PROCEDURE
For a detailed description of the UHP and RUN FLAT tyre demounting/mounting procedure,
please refer to the instructions in the manual developed by WDK (German Tyre Industry
Association).
9.8. TYRE INFLATION
9.8.A. SAFETY INDICATIONS
5,6.2)(;3/26,21
1HYHUH[FHHGW\UHSUHVVXUHUHFRPPHQGHGE\
W\UHPDQXIDFWXUHU
$OZD\VPDWFKWKHW\UHDQGULPGLPHQVLRQV
7DNHFDUHWRDYRLGDQ\GDPDJHWRWKHW\UH
'XULQJLQIODWLRQNHHSRXWVLGHWKHYHUWLFDO
F\OLQGHUDUHDRFFXSLHGE\WKHZKHHO
DANGER
29