128 ProLine 124-221-321-324 Operator manual
It is not permitted to use inflation devices (e.g. gun) connected to power sources
outside the machine.
DANGER
Always observe national safety regulations, which can be more restrictive than this
manual, according to the principle that a higher standard prevails over a lower one.
WARNING
If the tyre operating pressure, required for
a certain vehicle, exceeds the value of the
inflation limiting valve, it should be obtained
by positioning the tyre and wheel on a suitable
safety device
Pay attention to possible injuries
.Carefully read, understand and follow the
instructions below.
1. Overinflated tyres can explode, producing hazardous flying debris that may result in
an accident.
2. Tyres and rims that do not have the same diameter are “mismatched”. Never attempt
to mount or inflate any tyre and rim that are mismatched. For example, never mount a
16” tyre on a 16,5” rim (or vice versa). It is very dangerous. Tyres and rims that do not
correspond could explode and cause accidents.
3. Never exceed the inflation pressure for the tyre indicated by the manufacturer.
Carefully check that the air hose is well inserted in the valve.
4. Never bring your head or other body parts close to a tyre during inflation or bead
insertion operations.
This machine is not a safety device against the possible risk of explosion of tyres, air
chambers or rims.
5. Maintain a suitable distance from the tyre changer while inflating. Do not approach it.
DANGER
WARNING
To Next Page
Loading...
