106 ProLine 124-221-321-324 Operator manual
- Fit the head guard (Fig. 5H) fasten with screws and
washers.
- Fit the pole guard (Fig. 5I) fasten with screws and
washers.
- Install the inflation pressure gauge box on the pole
(Fig. 5L).
- Tilting adjustment (Fig. 5M): the speed of the pole
tilting must be adjusted not higher than 0.71 rad/s. After
many tilting cycles over time, it may be necessary to
re-calibrate. Adjust valves A on the cylinder, by turning
them clockwise the speed decreases, while counter-
clockwise it increases.
- Refit the side cover N (Fig. 5A).
ProLine 124 - 221
- Remove the side cover N (Fig. 6A).
O
Q
5G
5H
5I
6A
6B
P
P
5L
A
A
5M
To Next Page
Loading...
