ProLine 124-221-321-324 Operator manual 125
UK
- Press the turntable drive pedal
, making the wheel turn clockwise. The
upper bead will be automatically guided
up over the rim edge (fig. 26).
- Repeat the last three points to detach the
lower bead.
NOTES: If the tyre has an inner tube, after
detaching the upper bead, tilt the operating
arms into “non-working” position and remove
the inner tube before proceeding to demount
the lower bead.
The rotation of the turntable can be stopped
at any time by releasing the pedal.
To rotate in the opposite direction, simply
raise up the pedal.
- Lift the second bead manually on the head, then rotate the turntable clockwise until
the tyre has been completely demounted from the rim.
- Move the operating arms to the “non-working” position.
If the tyre has an inner tube, after demounting the upper bead, tilt the column back
and remove the inner tube before proceeding to demount the lower bead.
Turntable rotation can be stopped at any moment by releasing the drive pedal.
To rotate in the opposite direction, simply raise up the pedal.
WARNING
25A
D
D
26
To Next Page
Loading...
