ProLine 60 - Operator's Manual 47
UK
ALU3
Dis 1 = Dis
Dis 2 =
from 0 point to the outer of the flange disk - ½”
Dia 1 = Dia
Dia 2 = Dia - 2 ½”
6.7 SUPPLEMENTARY
EXPLAINATION
Once switching on, you will see standard dyna-
mic balance mode setup by the computer. When
selecting ALU mode and the configuration of the
aluminum alloy rim is similar to the above standard
ALU1\ALU2\ALU3, you can get relative accurate
balance effect. If the section of the tire similar to
the one given be the program, you need do some
adjustment on the position and weight of the
weight. General speaking, 1~2 times of adjustment
can reach relative satisfactory balance effect.
7. PROGRAM SETUP
7.1 PROGRAM FUNCTION
INTRODUCTION
Press program key to enter the program
setup menu.
-p- (protective cover setup) and then press
key to confirm the entrance.
Select to set the on/off of
the protective cover function.
Then press key to return to the upper level.
SP (protective cover control function setup)
Select to enter.
And press key to enter.
The setup is same to the above.
APP (Balance unit setup) can setup 1Gr and 5Gr.
The setup is same to the above.
BIP (beeper setup) can setup the on/off of the
beeper. The setup is same to the above.
SET UP Press to enter the special fun-
ction setup.
IN TES (sensor test) to test the photocell and
STA/DYN sensor.
Next menu: Select to enter
[CAL] –[CAL].
This function is used when the machine has not
been used for long time or the balancing is not
accurate.
Self-calibration program setup: Press to
enter into the program and then press to
Confirm and the display will display ADD -0. Press
the start key to start the test. After running, the
display will display ADD -100, rotate the tire until
all of the unbalance position lamp light up. Clip
a weight of 100g at the 12 clock position on the
tire. Once again start the machine to realize the
self-calibration of the machine. Enter the shortcut
method of the self-calibration program and hold on
pressing for 5 seconds and enter “ADD”-“0”.
The above operation step vector diagram is as
follows:
To Next Page
Loading...
