corob D700 extra - Page 17

FEATURES - 13
COROB™ D600 - D700 - D800 EXTRA
Can centering device
On the machine accessorized with punching system, a centering device is
mounted on the shelf. The can centering device is custom-made based on the
size of the cans to be handled and is useful for aligning them with the nozzle
center, so that the can lid is punched in the middle and dispensing takes place
precisely into the hole created. The can centering device is also available as an
optional accessory to the standard machine, useful for positioning pre-punched
cans right under the dispensing center.
Bung Hole Locator (B.H.L.)
This is a system that emits laser beams that allow the positioning of pre-punched
cans, so that the hole is in line with the center of the dispensing nozzles.
Nozzle Humidier Cap
Colorants tend to dry out; this tendency may be more or less strong depending
on the type of colorant and the environment conditions (temperature, relative
humidity, etc.). To prevent colorants from drying out in the nozzle center, the
machine is equipped with a humidier cap which requires constant maintenance.
The Lift-up Autocap is an automatic humidier cap which ensures that
the nozzles are hermetically sealed. It is managed by the software,
which opens it automatically before dispensing and closes it immediately
afterwards.
Manually-operated automatic puncher
The puncher is a device that perforates the can lid. Punching is carried out by
the operator by pushing contemporaneously the semiautomatic shelf activation
buttons (two-handed control); thanks to the upward movement, the shelf pushes
the can resting on it against the puncher, and with a downward movement
brings it to the correct position for dispensing.
No-Dry-Nozzle Humidier System
The humidier system for water-based colorants guarantees the nozzles are
humidied not only with Autocap closed but also during dispensing. The air,
humidied by the water contained in the bottle, is transferred to the nozzles
area. Based on the humidity level detected, the system activates or shuts off
whenever needed.
The humidier system for solvent-based colorants humidies the nozzles when
Autocap is closed. The solvent, contained in a small tank inside the Autocap,
keeps the nozzles area constantly saturated.
The two systems can be used individually or together according to the tinting
system used on the machine.
MAX
MIN