16 - SHIPPING, HANDLING AND UNPACKING
COROB™ D600 - D700 - D800 EXTRA
DANGER
When using colorants containing volatile solvents the room in which the machine is installed must be
spacious, with good ventilation (air exchange) and no type of parts must be leant against or stocked close
to the machine.
If the machine is installed near a wall, keep it at least 4” (10 cm) away to allow the upper covers to be
opened and prevent the cables from being crushed.
4.3 Unpacking and placement
1 x 10 mm
2 x 17 mm
To remove the xing brackets
DANGER
The following procedure must be carried out by at least 2 people.
Store the packing material for future use, or dispose of it according to current regulations. In any case, we
recommend that you keep it for the entire duration of the machine warranty.
Make sure the packing has not suffered any damage or tampering during shipping; if so, contact the
authorized technical service or your dealer.
1. Cut the straps wrapped around the packing.
2. Remove the covering from the pallet.
3. Remove machine wrapping.
1 2 3
Figure 5
DANGER
Should the machine appear damaged during shipping, do not attempt to start it and contact the authorized
technical service or dealer.
4. Loosen all screws A holding the brackets to the machine.
5. Lower the feet (chapter 4.3.1) so that the machine is slightly raised from the wooden beams on which it
rests.
6. Remove the wooden beams B.
To Next Page
Loading...
