corob D700 extra - Quick Guide

COROB™ AUTOMATIC DISPENSER
QUICK GUIDE
At the beginning of the working day
• Check that the nozzle center is clean.
• (With humidier system for solvent-based colorants or without humidier system) Check that the sponge
is clean and saturated; if it is necessary to saturate, use only appropriate liquid (the choice of the liquid
depends on the nature of the colorants, and must be done directly by the manufacturer of the products
used).
• (With humidier system for water-based colorants) Check that the water in the bottle is not below the
minimum level.
• Carry out system Initialization and Purge.
Things to remember
• Never let the machine OFF.
• In the canisters, stirring of each colorant takes place automatically (stirring times can however be
customized).
• Be careful not to ll the canisters with too much colorant. In case of overlling, act as indicated in the user’s
manual.
• The colorant to be poured inside the canisters must be stirred manually. Do not use automatic shakers.
• Close the canisters with their lids right after lling operations.
• Remember to update accordingly the canisters lling levels via the management software.
• (With humidier system for solvent-based colorants or without humidier system) The sponge must be
saturated at least twice a week (the frequency of intervention is indicative, since it depends on the nature
of colorants and the environment conditions).
• (With humidier system for water-based colorants) Top up the water bottle as soon as the minimum level is
reached. Do not exceed the maximum level.
At the end of the working day
• Rell the canisters.
• Update the canister lling levels in the management software.
• Shut down the computer. Do not shut off the machine.
It is recommended to carefully read the user’s manual.