ORDINARY MAINTENANCE - 33
7.6 Cleaning and moistening the humidier cap sponge
In case of sponge replacement, use only those supplied with the machine.
1. Disconnect power supply (chapter 5.6).
2. Open the cap by pushing the opening bar inward with your hand.
3. Unscrew the sponge holding cup and remove it.
4. Bring back the cap in its closed position.
5. Wash the sponge holding cup, check the condition of the sponge and moisten as needed. The level of the
humidifying liquid must not exceed the height of the sponge. If it is very dirty, remove the sponge from the
cap and wash it thoroughly. If the sponge is severely damaged, replace it.
6. Open the cap with your hand and reinstall the sponge holding cup.
7. Connect power supply and switch on the machine (chapter 5.3).
Figure 15
To Next Page
Loading...
