TECHNICAL SPECIFICATIONS - 35
8 TECHNICAL SPECIFICATIONS
8.1 Technical data
Power supply Single-phase 100 - 240 V ~ ± 10%
Frequency 50/60 Hz
Fuses* F 10 A
Maximum power absorbed*
180/250 W - simultaneous
90 W - sequential
Noise level Level of equivalent acoustic pressure: < 70 dB (A)
Environment working conditions**
Temperature: between 10 °C (50 °F) and 40 °C (104 °F)
Relative humidity: between 5% and 85%, without condensation
Vibrations
The machine does not transmit vibrations to the oor that may
compromise the stability and precision of any nearby equipment.
Dispensing technology bellow pump
Dispensing system sequential or simultaneous
Type of canisters all-purpose (POM acetalic resin)
Type of valves check valves
Dispensing center internal
Nozzle center ow diameter*** 31 mm
****
Machine 110 kg (12 circuits version) - 148 kg (16 circuits version)
Packed machine 140 kg (12 circuits version) - 175 kg (16 circuits version)
* The power information is purely indicative, and depends strictly on the machine conguration.
** The environment working conditions are strictly related to the type of colorants used (ask for information from the paint manufacturer).
The data shown are valid for the machine only.
*** Hole diameter for pre-punched cans = ow diameter + 15 mm.
**** Data refer to the machine with empty canisters.
Standard circuit
Flow rate (theoretical at 100 rpm) 0.2 l/min
Minimum dispensed quantity*
1/384 US oz
(0.077 ml)
Theoretical resolution* 0.00625 cc/step
* Values highly affected by the nature of the colorants and their rheological properties.
To Next Page
Loading...
