EasyManua.ls Logo

COZY CF403D-H - Lighting Instructions

COZY CF403D-H
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1018029-E Page 12
A.        
lighted by hand. When lighting the pilot,

B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
       

WHAT TO DO IF YOU SMELL GAS:
DO NOT try to light any appliance.
DO NOT
DO NOT use any phone in your building.
Immediately call your gas supplier from

supplier’s instructions.
FOR YOUR SAFETY READ BEFORE LIGHTING
MODELS: CF403D-H / CF404D-H / CF553D-H / CF554D-H
If you cannot reach your gas supplier, call

C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob


Force or attempted repair may result in a

D. Do not use this appliance if any part has
     
     
appliance and to replace any part of the
      

6. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP!        
label. If you don’t smell gas, go to the next step.
7. Locate red piezo ignitor button on side of gas control.
       
tube from gas control).
8.  to

LIGHTING INSTRUCTIONS - ( Standing Pilot )
WARNING:
If you do not
follow these
instructions
exactly, a re
or explosion
may result
causing
property
damage,
personal
injury or loss
of life.
LIGHTING INSTRUCTIONS
TURNING OFF GAS TO APPLIANCE
1. STOP!
2. 
3. 󰀨
4. 
5.         

1. 
2. 
is to be performed.
3. 
4. 

5. 
9. Push in pilot control knob and hold in. Immediately
begin a series of pushing and releasing the red

the sight glass. Continue to spark until pilot is lit.
Continue to hold the pilot control knob in for about

         
remain lit. If pilot goes out, repeat steps 5 thru 9.
- If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
- If the pilot will not stay lit after several tries, turn the gas
control knob to “OFF” and call your service technician
or gas supplier.
10.  
11. 
12. Turn on all electric to the appliance.
13. Set thermostat to desired setting.
Pilot Burner
The pilot is
located on the
side of the
burner.
HONEYWELL
TH-TR
ON
C
OFF
PILOT
NOTE:
Knob cannot
be turned from
“PILOT” to “OFF”
unless knob is
pushed in slightly.
Do not force.
Gas Control Knob
Pilot Control Knob