1018029-E_03/22Page 19
306SR-A
SIDE DISCHARGE ON CASING ( Flush Mount )
30SRB-A
SIDE DISCHARGE ( With Extension Boot )
KITS (Optional Accessories)
CAUTION: These kits must be installed by a qualified installer or service technician.
1. Cut out and remove embossed area on casing side.
2.
3.
4.
5.
6.
7. Place grille into position, drill holes into casing, and
1.
2.
3. Cut out and remove embossed section on casing side.
4.
5. Put heater into position.
6.
7. Place boot trim into position, slide inner boot through
to casing side.
8.
FIG. 19
Min.
FIG. 20
To Next Page
