1018029-E Page 18
FIG. 18-A
Side Wall
Plaster
Ground
1. Figure 18-A.
2. Cut out and remove embossed section on casing rear.
3.
4. Place inner boot from kit through opening, matching
5.
6.
7.
8.
9.
10.
11. Figure 18-B.
406RR-A
REAR REGISTER KIT ( Flush Mount )
407RR-A
REAR DISCHARGE KIT ( Recessed )
KITS (Optional Accessories)
CAUTION: These kits must be installed by a qualified installer or service technician.
FIG. 18-B
FIG. 17-A
Plaster Ground 1/2”
14-1/2”
REAR
14-11/16”
1. Figure 17-A.
2. Figure 17-A
(Optional).
3. Cut out & remove embossed section on casing rear.
4.
5. Put heater into position.
6.
mark (4) holes from damper onto inner boot, top and
7. Attach inner boot to liner. Attach damper to inner boot
8.
9. Figure 17-B.
FIG. 17-B
To Next Page
