CP Plus CP-UNR-1xxQ1 Series - Page 26

18
2.1.4 CP-UNR-2xxQ2_ CP-UNR-2xxQ2P Series
The front panel is shown as below. See Figure 2-5.
Figure 2-5
Please refer to the following sheet for front panel button information.
Name
Icon
Function
Power button
Power button, press this button for three seconds to boot up
or shut down NVR.
USB2.0 port
To connect USB storage device, USB mouse, burner and
etc.
Up/1
Down/4
,
 Activate current control, modify setup, and then move
up and down.
 Change setup. Increase/decrease numeral.
 Assistant function such as PTZ menu.
Left/2
Right/3
, 
Shift current activated control, move left or right.
When playback, click these buttons to control playback bar.
Play/Pause /5

In normal playback click this button to start/pause playback.
Reverse/Pause
/6

In normal playback or pause mode, click this button to
reverse playback.
Fast play/7

Various fast speeds and normal playback.
Slow play/8
Multiple slow play speeds or normal playback.
Play Next/9
│
In playback mode, playback the next video
Play previous/0
│
In playback mode, playback the previous video.
HDD abnormal
indication light
HDD
HDD error occurs or HDD capacity is below specified
threshold value, the light becomes red to alert you.
Network
abnormal
indication light
Net
Network error occurs or there is no network connection, the
light becomes red to alert you.
Record light
1-16
System is recording or not. It becomes on when system is
recording.
IR Receiver
IR
It is to receive the signal from the remote control.
ESC
Esc
 Go to previous menu, or cancel current operation.
 When playback, click it to restore real-time monitor
mode.