109
6.3 Power ON/OFF
6.3.1 Manual Power ON/OFF
Restarting the inverter is required after regulation setting or manual (fault)
shut-down. Press ESC or ENT to access the Main Menu. Scroll the curser
down to highlight POWER ON/OFF and press ENT to select. Move the
cursor to “ON” and press ENT to start the inverter. The inverter will start up
and operate normally if the start-up conditions are met. Otherwise, the
inverter will go to stand-by mode.
Normally, it is not necessary to Turn OFF the inverter, but it can be shut
down manually if regulation setting or maintenance is required. Move the
cursor from the main operation interface to POWER ON/OFF and press
ENT. Move the cursor to “OFF” and press ENT, and then the inverter will
be shut down.
6.3.2 Automatic Turn ON/OFF
The inverter will start up automatically when the output voltage and power
of PV arrays meet the set value, AC power grid is normal, and the ambient
temperature is within allowable operating range.
The inverter will be shut down automatically when the output voltage and
power of PV modules are lower than the set value, the AC power grid fails,
or the ambient temperature exceeds the normal range.
To Next Page
Loading...
