WARNING:
All the installation and wiring connections must be performed
by qualified technical personnel. Disconnect the inverter from
the PV modules and the AC grid before maintaining or
servicing the equipment.
Risk of electric shock and fire. Use only with PV modules
that have a maximum system voltage of rating of 1000V
DC
or
higher.
Electric shock Hazard. The DC conductors of this
photovoltaic system are normally ungrounded but will become
intermittently grounded without indication when the inverter
performs the PV array isolation measurement.
Shock Hazard. The inverter is energized from both AC and
DC sources. Disconnect all energy sources before servicing.
For continued protection against risk of fire, replace only with
same type and ratings of fuse.
DANGER:
Disconnect the inverter from the AC grid and PV modules
before removing covers or opening the equipment. Wait at
least 5 minutes after disconnecting from the DC and AC
sources before servicing or maintaining the inverter. Ensure
hazardous high voltage and energy inside the inverter has
been discharged prior to servicing.
NOTICE:
The inverters are designed to only interconnect with an AC
power source as part of the public electric utility grid. Do not
connect the AC output of the inverters directly to any private
electric utility power equipment. The inverters are to be
installed with floating or ungrounded PV arrays only.
To Next Page
Loading...
