©2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
32
User Manual / AER2100
4/19/16
• Smart Selection (Default) – Scans to determine the lowest interference WiFi channel
Channel Selection Schedule: When using the “Smart” channel selection, this controls whether the router will
Channel: (Shows if User Selection
communicate with other devices. For 2.4 GHz, the range is 1 to 11, and 1, 6, and 11 do not overlap each other.
Select a channel from the dropdown list:
• 1 (2412 MHz)
• 2 (2417 MHz)
• 3 (2422 MHz)
• 4 (2427 MHz)
• 5 (2432 MHz)
• 6 (2437 MHz)
• 7 (2442 MHz)
• 8 (2447 MHz)
• 9 (2452 MHz)
• 10 (2457 MHz)
• 11 (2462 MHz)
For 5.0 GHz, the ranges are 36 to 64 and 149 to 165.
• 36 (5180 MHz)
• 40 (5200 MHz)
• 44 (5220 MHz)
• 48 (5240 MHz)
• 149 (5745 MHz)
• 153 (5765 MHz)
• 157 (5785 MHz)
• 161 (5805 MHz)
• 165 (5825 MHz)
* - Channels listed above represent US/FCC settings. EU users will see different settings.
Client Timeout: If the access point is not able to communicate with the client it will disconnect it after this
timeout (in seconds).
TX Power
RTS Threshold: When an excessive number of wireless packet collisions are occurring, wireless performance
RTS Threshold. This setting should remain at its default value.
Fragmentation Threshold: Wireless frames can be divided into smaller units (fragments) to improve
performance in the presence of RF interference and at the limits of RF coverage. Fragmentation will occur
DTIM: A DTIM is a countdown informing clients of the next window for listening to broadcast and multicast
sends the next DTIM with a DTIM Interval value. Wireless clients detect the beacons and awaken to receive the
broadcast and multicast messages. The default value is 1. Valid settings are between 1 and 255.
To Next Page
