SANDING CURVED EDGES
CURVED EDGES
Sand inside curves on the idler pulley.
Sand outside curves on the sanding disc.
.... _ : .i.,_,. L J u _ , ,I I I, : .4!
SANDING SMALL END SURFACES ON THE
SANDING DiSC
Move the work across the center to the left side
of the face of the sanding disc. For accuracy,
use a miter gauge (accessory).
NOTE: Use a combination square to square the
miter gauge to the face of the disc (combination
square must be "true" -- See Start of Assembly
section on page 6 for checking method). If it is
not square, Joosen the miter gauge knob and
move the miter gauge slightly until it is square.
Without moving the miter gauge, tighten the
knob securely.
COMBINATIONSQUARE
...::'..
17
To Next Page
Loading...
