i into
the ::way
SANDING
PLATE
SANDING
D_SC
INSTALLING BACKSTOP
1_ Locate backstop, hex bolt 1/4-20xVz inch, and
a 1/4 inch flat washer,
2: Hold backstop into position and fasten with
bolt and washer as shown. Do not overtight-
en.
INSTALLIN G TABLE ASSEM BLY
1,:Locate table support rod, knob and
5t16-18×3t4 bOlt:among loose parts.
2: Insertrod in base as shown, leaving 5 inches
of rod extending outside base.
ii rllll i ii iiiii i
3. Install bolt in base (align a flat side of rod to
bolt) and tighten with 7116-inch wrench.
: i
i:::i:::i¸:!_i:i _¸
ii •
10
To Next Page
Loading...
